Next Event

Media Info
    News releases
    Fact sheets
    Interview us
    Myths & truth
    Gun dictionary    
    Scary words
    SEA Effects
   
FAQ

Photos & Videos
Training
News Coverage
General Info
Directions
History
Explosive Experiments
Bomb Help (NOT!)
Contact
Links

Home
Shirts, hats, stuff
Join News List
Privacy Policy

Reloading Supplies
Reloading Data

Second Amendment Foundation banner

Taj Mahal -- A Type 1 Explosives Magazine

The following are pictures, sketches, and descriptions of the newest explosives magazine which has been named Taj Mahal.


The location of the new magazine is in the lower left corner of the sketch above.


The magazine is located inside a 10' x 14' steel shed.


The steel reinforcing iron in the concrete floor is only partially installed in the picture.

The walls and top are made of 1/2" steel.  The walls have 3/8" plywood lining them.  The plywood is held in place by 1.25" screws from the outside that go through the plywood and into 1/2" pine slats (not shown in the drawing above).  The screws are only exposed on the outside.

The door is 5/8" steel.  The inside of the door is painted with epoxy paint.  The shackleless locks and hardened hasps pictures are below.

The steel reinforced concrete floor is covered with a anti-static treated polypropylene, rubber backed rug.  The bolts holding the 3000 pound magazine to the floor are painted with epoxy paint also.


There are shielded vents on the bottoms of the side and on the top.  Pictures are shown below.


Shielded top vent.

Screens were added to the openings after the magazine was painted.


Shielded side vent.

Screens were added to the openings after the magazine was painted.


Door with locks attached.  Side vent, still without screens can be seen at the lower right.


One of two Series 2000 shackleless American Locks with six pin tumblers used on the door.

horizontal rule

Email: Joe Huffman
Last updated: June 27, 2008